This can be gluing, sanding, painting, etc. This model is meant to be post-processed after printing. We try to make the models in a way that uses as little support material as possible. We use these settings for most of our prints:įor parts that are tall but have a small base, we use a 10 mm brim for better bed adhesion. It is good to make it bigger and then add cushioning to the inside for a snug and comfortable fit, but we can’t guarantee that at a much smaller size the model will print well. You can scale the model according to your head measurements. All cut parts are placed on the print bed as we would print them to save you time.Īt 100% scale the mask’s dimensions with tubes are approximately: The download contains pieces of the model ready to be 3D printed on a 200 mm print bed and files that are not cut into smaller pieces. The filter grid is put in place from the inside. We recommend using a red plastic sheet instead of the eyes provided. Most parts are connected via pins that can also be printed. The model also contains optional part that can be put on the back of your neck to make it look like a Dark Trooper’s neck. It was carefully modelled to closely resemble the ferocious Dark Troopers.
This is a digital 3D printable model of Dark Trooper’s Head from Disney’s The Mandalorian.
0 kommentar(er)
